Supercharger Rebuild Repair kit fit Jaguar Land Rover Range Rover 5.0 5L TVS

Description

5.0 Liter Jaguar / Land Rover Supercharger
GENUINE EATON PARTS
Eaton is the manufacturer of the Supercharger
EATON Supercharger Snout Bearings (qty 2)
EATON Supercharger Drive Hub (steel 3 pin part) (qty 2)
EATON Supercharger Inlet Needle Bearings (qty 2)
EATON Replacement Isolator/Coupler Made by Eaton
EATON Supercharger Oil 8 oz (5.1 oz required)
EATON Drain Plug
Syringe and tub to assist removing oil & refilling
Anaerobic sealer to seal the rear rotor pack cover
You need RTV to seal the snout
to the supercharger!
(not included)
Does not fit 3.0 liter engines
Installation Notes:
The snout is sealed to the supercharger with RTV (silicone), scrap off the old and apply some new sparingly. There is one bolt in the snout inlet on some superchargers, see 2nd picture. The TB gasket is reusable but a new one is C2Z28265. I recommend a bolt torque of 18 ft-lb for the snout bolts.
You need RTV to seal the snout
to the supercharger!
(not included)
Supercharger Tear Down
youtu.be/BF9o6L_qd9E
Needle Bearing Install
youtu.be/122i15j3OK8
Tools used to remove Drive Hub & Needle Bearings
www.ebay.com/itm/114135604790
Drive Hub Puller
www.ebay.com/itm/113825453061